The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> applying changes to test.par file in the editor https://designers-guide.org/forum/YaBB.pl?num=1524239741 Message started by maxcy on Apr 20th, 2018, 8:55am |
Title: applying changes to test.par file in the editor Post by maxcy on Apr 20th, 2018, 8:55am When I go into the run/simulate tool and edit the test.par file, how do I make these changes take effect when I run a new simulation using the edited test.par file? I assume that the 'save(current buffer)' option is used to save the changes to the edited test.par file. While the 'save as(current buffer)' option will save these changes to the test.par file to a new file which can then be used to 'open' the selected file to run/compile the example. Do I have to 'synchronize' in the run/simulate tool to get this new/changed test.par file to work with the example? I can find no information on this subject in the published information so far. |
Title: Re: applying changes to test.par file in the editor Post by Geoffrey_Coram on Apr 23rd, 2018, 7:47am What simulator are you using? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |