The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Mixed-Signal Design >> Conversion Rate and Data Converters
https://designers-guide.org/forum/YaBB.pl?num=1587852816

Message started by repah on Apr 25^th, 2020, 3:13pm

Title: Conversion Rate and Data Converters
Post by repah on Apr 25^th, 2020, 3:13pm

I want to use Model Writer in Cadence Spectre to make verilog models of an ADC and DAC - 10 bit each.

My ADC has a 2ns conversion rate - I set this in the ADC block settings. Both ADC and DAC are clocked at 1MHz.

What should I set the conversion rate of the DAC to be and why ?