The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> PAC simulation issue https://designers-guide.org/forum/YaBB.pl?num=1623695038 Message started by iVenky on Jun 14th, 2021, 11:23am |
Title: PAC simulation issue Post by iVenky on Jun 14th, 2021, 11:23am Hi, I am facing a problem with pac simulation. This is the error that I see. ERROR (SPCRTRF-15168): No valid time points are specified for the sampled analysis `pac'. The analysis is skipped. To fix the problem, please verify that: 1) Threshold value is within the range of probed signal. 2) Additional timepoints are specified less than the fundamental period. It doesn't make sense because, The threshold value that I set is at 0.5*VDD so it is within the range of probed signal (verified with pss plot). I don't have any additional timepoints specified. Is there any other reason why this could be happening? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |