The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 5th, 2024, 5:12am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › How can I design SCF by Hspice?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How can I design SCF by Hspice? (Read 2161 times)
Roy
Guest
How can I design SCF by Hspice?
Jun 29th, 2004, 4:33am  
Hello,
 
  If the only design tool i can ues is hspice, how can i simulate the scf performance, such as frequency response..? please tell me, thanks a lot.
Back to top
 
 
  IP Logged
weiliang
New Member
*
Offline



Posts: 2
Re: How can I design SCF by Hspice?
Reply #1 - Jul 1st, 2004, 6:27pm  
As I know, you can do the transient simulation with various sinewave input and measure magnitudes of all input signal. However, such method will take a lot of time to complete simulation.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.