The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 15th, 2024, 9:06am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design Languages › Verilog-AMS › How to make accumulator module use verilog-A?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How to make accumulator module use verilog-A? (Read 3786 times)
icsoul
Junior Member
**
Offline



Posts: 29
How to make accumulator module use verilog-A?
May 11th, 2007, 1:18am  
Note: not verilog-AMS

Thanks for your help!!
Back to top
 
 
View Profile   IP Logged
makelo
Community Member
***
Offline



Posts: 34
Hillsboro, OR
Re: How to make accumulator module use verilog-A?
Reply #1 - May 22nd, 2007, 2:23pm  
You could build it up from the primitives given as examples in the modeling section.  There are plenty of VerilogA and, or, nands, and dff there.  This might be a good place to start.
Back to top
 
 
View Profile   IP Logged
icsoul
Junior Member
**
Offline



Posts: 29
Re: How to make accumulator module use verilog-A?
Reply #2 - May 25th, 2007, 2:38am  
Than you for your advice!
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.