The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 22nd, 2024, 3:37pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › can I manully choose the simulation sequence?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
can I manully choose the simulation sequence? (Read 2620 times)
RobertZ
Community Member
***
Offline

the art of analog

Posts: 55
San Diego, CA
can I manully choose the simulation sequence?
May 16th, 2007, 12:56am  
can I manully choose the simulation sequence in cadence ADE?

Thanks.
Back to top
 
 
Thanks,
Robert
View Profile   IP Logged
Frank Wiedmann
Community Fellow
*****
Offline



Posts: 678
Munich, Germany
Re: can I manully choose the simulation sequence?
Reply #1 - May 16th, 2007, 4:39am  
Yes, under Setup -> Environment -> Analysis Order.
Back to top
 
 
View Profile WWW   IP Logged
RobertZ
Community Member
***
Offline

the art of analog

Posts: 55
San Diego, CA
Re: can I manully choose the simulation sequence?
Reply #2 - May 16th, 2007, 10:23am  
Cool.
Back to top
 
 
Thanks,
Robert
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.