The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 21st, 2024, 7:56am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › AMS Simulators › cannot probing current in AMS-designer
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
cannot probing current in AMS-designer (Read 2694 times)
Pavel
Senior Member
****
Offline



Posts: 174
Lausanne/Switzerland
cannot probing current in AMS-designer
Jun 20th, 2007, 1:06am  
Hello

Trying to probe current in AMS designer I receive following error message (please, see the picture - on top).
What could be the reason of this message?
It seems that I correctly specified current to plot in save/Plot window (on picture in the midlle)
and specified currents to plot in Options/waveforms (on the picture down part)

Regards.

Pavel.
Back to top
current_probing.JPG  
 
current_probing.JPG
View Profile   IP Logged
boe
Community Fellow
*****
Offline



Posts: 615
Re: cannot probing current in AMS-designer
Reply #1 - Jun 20th, 2007, 2:34am  
Hi Pavel,
Try probing instance /L0 with object "Instance", type "Current (A)", depth "1".
This should save all port currents of the instance.

Hope this helps ...
BOE
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.