Forum
Forum
Verilog-AMS
Analysis
Modeling
Design
Theory
Welcome, Guest. Please
Login
or
Register.
Please follow the Forum
guidelines
.
Jul 21
st
, 2024, 10:25am
Home
Help
Search
Login
Register
PM to admin
The Designer's Guide Community Forum
›
Simulators
›
Circuit Simulators
› how to run corner analysis in cadence tsmc 0.35 design kit
‹
Previous topic
|
Next topic
›
Pages: 1
how to run corner analysis in cadence tsmc 0.35 design kit (Read 2536 times)
nus_lin
Community Member
Offline
Posts: 48
how to run corner analysis in cadence tsmc 0.35 design kit
Aug 12
th
, 2008, 3:17am
hi, guys.
i just shifted from AMS process to TSMC process. is there anybody familiar with the design kits? would you please tell me how to setup the model library section to get the worse case simulation done?
Back to top
IP Logged
bernd
Senior Member
Offline
Posts: 229
Munich/Germany
Re: how to run corner analysis in cadence tsmc 0.35 design kit
Reply #1 -
Aug 13
th
, 2008, 1:34am
As far as I know the corner sections are explained in the header of the TSMC model library.
* bernd
Back to top
Just another lonesome cad guy
IP Logged
nus_lin
Community Member
Offline
Posts: 48
Re: how to run corner analysis in cadence tsmc 0.35 design kit
Reply #2 -
Aug 13
th
, 2008, 7:34am
solved, vielen danke!
Back to top
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent Posts
» 10 most recent Topics
Design
- RF Design
- Analog Design
- Mixed-Signal Design
- High-Speed I/O Design
- High-Power Design
- Mixed-Technology Design
Analog Verification
- Analog Functional Verification
- Analog Performance Verification
Measurements
- RF Measurements
- Phase Noise and Jitter Measurements
- Other Measurements
Modeling
- Semiconductor Devices
- Passive Devices
- Behavioral Models
- Transmission Lines and Other Distributed Devices
Design Languages
- Verilog-AMS
- VHDL-AMS
Simulators
»» Circuit Simulators
- RF Simulators
- AMS Simulators
- Timing Simulators
- System Simulators
- Logic Simulators
Other CAD Tools
- Entry Tools
- Physical Verification, Extraction and Analysis
- Unmet Needs in Analog CAD
General
- Tech Talk
- News
- Comments and Suggestions
- Opportunities
« Home
‹ Board
The Designer's Guide Community Forum
» Powered by
YaBB 2.2.2
!
YaBB
© 2000-2008. All Rights Reserved.
Copyright 2002-2024
Designer’s Guide Consulting, Inc.
Designer’s Guide
® is a registered trademark of
Designer’s Guide Consulting, Inc.
All rights reserved.
Send comments or questions to
editor@designers-guide.org
. Consider
submitting
a paper or model.