The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 21st, 2024, 5:24am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › HSPICE model file loading issue in SPECTRE
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
HSPICE model file loading issue in SPECTRE (Read 1761 times)
nube_human
New Member
*
Offline



Posts: 3
T.O.
HSPICE model file loading issue in SPECTRE
Oct 15th, 2008, 9:35pm  
I am trying to load an HSPICE model file in a SPECTRE simulation. I have successfully done this in the past with

simulator lang=spectre

However this file has a

.prot
<encrypted>
.unprot

construct, and results in a syntax error due to encrypted portion.

Any ideas on how to get it to work.

Thanks in advance,
NH
Back to top
 
 

-- NH
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: HSPICE model file loading issue in SPECTRE
Reply #1 - Oct 16th, 2008, 9:47am  
I doubt you can do anything about this -- not likely that Synopsys is going to give Cadence Synopsys's decryption key.  Not only because they are competitors, and Synopsys wants you to buy HSpice, but what if Cadence "accidentally" disclosed the key?
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.