The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 7:40pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design Languages › Verilog-AMS › wreal bidirectionality - Any solution ?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
wreal bidirectionality - Any solution ? (Read 2236 times)
lusorg
New Member
*
Offline



Posts: 1
wreal bidirectionality - Any solution ?
Jan 16th, 2009, 7:03am  
Hi all,

I need model simple in/out block using wreal.

It's is possible ? Because i cannot use Z to open connection.

Thanks all.
Back to top
 
 
View Profile   IP Logged
jbdavid
Community Fellow
*****
Offline



Posts: 378
Silicon Valley
Re: wreal bidirectionality - Any solution ?
Reply #1 - Jan 16th, 2009, 3:08pm  
I know of no wreal implementation that supports that yet.
Maybe you need to try some of the other ways of extending verilog.
Back to top
 
 
jbdavid
Mixed Signal Design Verification
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.