The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 1:20am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › hspice in ADE
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
hspice in ADE (Read 1649 times)
sivacha
Junior Member
**
Offline



Posts: 17
India
hspice in ADE
Oct 11th, 2010, 3:06am  
Hi

When i tried to run hspice on any schematic through ADE, i am getting some error like " Enter the name of the output file: (input.lis) " in the log window. But i can not edit log file.

Where can I enter the output file name?
Can any body suggest a solution???

Thanks.
Back to top
 
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: hspice in ADE
Reply #1 - Oct 11th, 2010, 10:22am  
Probably your ADE isn't configured properly.  I think there's a command-line argument that tells HSpice to use input.lis without prompting (assuming the netlist was input.sp).
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.