The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 9:22am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › How to do post-layout simulation with Calibre netlist in ADE?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How to do post-layout simulation with Calibre netlist in ADE? (Read 1753 times)
Yutao Liu
Community Member
***
Offline



Posts: 76
Guangzhou, China
How to do post-layout simulation with Calibre netlist in ADE?
Nov 07th, 2010, 6:15am  
Dear all,
I am using Cadence 6.1. And I want to know how to do post-layout simulation in ADE while the netlist is generated by Calibre?

Thanks in advance.

Yutao
Back to top
 
 
View Profile   IP Logged
Paul H
New Member
*
Offline



Posts: 4
Re: How to do post-layout simulation with Calibre netlist in ADE?
Reply #1 - Nov 25th, 2010, 1:51am  
The simplest method of doing this is to extract your layout to a Calibreview instead of a netlist and then change your switch view list to include this view when netlisting from your test bench top level.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.