The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 7:18am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › how to plot part of the waveform in cadence ADE
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
how to plot part of the waveform in cadence ADE (Read 1558 times)
xuedashun
Junior Member
**
Offline



Posts: 18
how to plot part of the waveform in cadence ADE
Nov 08th, 2010, 12:38pm  
I have 100us simulation result. If the startup part (say 0-5us) is not good and I don't want to plot it at all. I want to plot is from 5us-100us.

Is there any way to set the 5us-100us as a default option so that it can be plotted automatically each time after the simulation is done? Thank you!
Back to top
 
 
View Profile   IP Logged
aamar
Community Member
***
Offline



Posts: 57
Germany
Re: how to plot part of the waveform in cadence ADE
Reply #1 - Nov 8th, 2010, 11:34pm  
In the chossing analysis window, where do you setup the transient analysis parameters, there is an option button. Choose it and set the outputstart in it to the 5u.

Best regards,

aamar
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.