mjun0mjun
New Member
Offline
Posts: 5
|
Hi guys,
I met a problem in my post_simulation which cost me much time. I used Calibre to extract parasitic parameters. And in the generated Calibre view I find something strange, that is, all the parasitic capacitors to ground are connected to node '0', not my ground in the design--'agnd', and the node '0' is connected to the 'agnd' through a capacitor. Part of the printscreen of the Calibre view is shown in the figure 0_gnd.JPG below. What's more, I simulate the voltage of the node '0', which is not constant zero, but changes with time. So all the simulation results are wrong. Could someone help me figure this out?
Thank you~~ Ma Jun
|