Designer’s Guide Community

Pages: 1

Jitter Measurement using eye diagram in cadence (Read 3341 times)

nadroit Junior Member Offline Posts: 14	Jitter Measurement using eye diagram in cadence May 28^th, 2012, 4:00pm Hello All, I used Ken's Verilog-A code of VCO with jitter. I set jitter input to 10ps and ran transient simulation. Then I plotted eye diagram of output but I don't know hoe to measure jitter from eye diagram in cadence. Please help. I am using IC5.1 Thanks
Back to top	IP Logged

ywguo

Community Fellow

Offline

Posts: 943
Shanghai, PRC

Re: Jitter Measurement using eye diagram in cadence
Reply #1 - Jun 13^th, 2012, 6:31pm

Hi nadroit,

If you cannot access cadence online help, generate eye diagram of the VCO output and measure it with delta cursors. �

If you can access cadence online help, please have a look at solution # 11395772, 11018920, and 11564054. Or have a look at the following link.
http://www.designers-guide.org/Forum/YaBB.pl?num=1293197122/0#0

BTW, I am not sure whether the solution in the above 3 solutions are all compatible with your product version, IC51.

Best Regards,
Yawei

IP Logged

Pages: 1

‹ Previous topic | Next topic ›