The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 8:40pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design Languages › Verilog-AMS › resistor change using veriloga
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
resistor change using veriloga (Read 2084 times)
sen
New Member
*
Offline



Posts: 1
resistor change using veriloga
May 16th, 2013, 8:04pm  
I want to code resistor change with change in temperature and strain. how should I go about it? Roll Eyes Undecided

Thanks in advance
Smiley
Back to top
 
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: resistor change using veriloga
Reply #1 - Jul 23rd, 2013, 12:48pm  
Do you need self-heating or just a temperature coefficient (applied to the ambient temperature)?

Is the strain applied dynamically?  Verilog-A would allow you to model the force applied to a model with a mechanical discipline.
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.