The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 18th, 2024, 10:04am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › AMS Simulators › How can I conver config view in an amsd block
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
How can I conver config view in an amsd block (Read 2082 times)
AMS_ei
Community Member
***
Offline



Posts: 67
How can I conver config view in an amsd block
Mar 18th, 2017, 10:26pm  
Hi,

I have a big config view in my ams setup in the gui mode. Now, I want to run the same config view in the irun command.
How can I convert a config view into an amsd block? Is there any automated script for that in cadence?

Thank you.

Kind regards,
Back to top
 
 
View Profile   IP Logged
Andrew Beckett
Senior Fellow
******
Offline

Life, don't talk to
me about Life...

Posts: 1742
Bracknell, UK
Re: How can I conver config view in an amsd block
Reply #1 - Mar 20th, 2017, 8:12am  
Probably the simplest approach is to use the runams command to netlist and run the simulation. This will then create the various files you need (you can choose to run the simulation or not).

Regards,

Andrew.
Back to top
 
 
View Profile WWW   IP Logged
AMS_ei
Community Member
***
Offline



Posts: 67
Re: How can I conver config view in an amsd block
Reply #2 - Apr 19th, 2017, 4:01pm  
Thank you, Andrew.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.