miles2018
New Member
Offline
Posts: 2
|
I'm using ic51 to streamin cdl to schematic(BUF), but get wrong mos value w=0 and l=0. I guess this was caused by the variables defined in the IVG, is there way deal with it ? my cdl like: .SUBCKT IVG A Z VDD GND MN0 Z A GND GND NM L=NL W=NW MP0 Z A VDD VDD PM L=PL W=PW .ENDS .SUBCKT BUF VDD GND A Z XI1 NET4 Z VDD GND IVG PW=0.7U PL=0.13U NW=0.3U NL=0.13U .ENDS
my devmap like: devMap := nfet nmos4 propMatch : subType NM termMap := D D G G S S B B propMap := W w L l M m addPorp := model NCH
devMap := pfet pmos4 propMatch : subType PM termMap := D D G G S S B B propMap := W w L l M m addPorp := model PCH
|