The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 5th, 2024, 5:34am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Analog Design › Pole-Zero Simulation with Spectre
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Pole-Zero Simulation with Spectre (Read 3378 times)
OpAmp
New Member
*
Offline



Posts: 8
Pole-Zero Simulation with Spectre
Dec 11th, 2004, 10:33am  
Hi,

I used to do pole-zero simulation with HSPICE (with .pz ).  Right now, I am going to do it with Spectre, however,  I do not know how to do that

Can anybody help me?

Thanks in advance
Back to top
 
 
View Profile   IP Logged
sheldon
Community Fellow
*****
Offline



Posts: 751
Re: Pole-Zero Simulation with Spectre
Reply #1 - Dec 11th, 2004, 10:13pm  
Hi,

  Pole-Zero analysis was added to Spectre in IC5033. The
command is pz.  Check spectre -h pz for the details or look
at SourceLink.

                                                        Best Regards,

                                                           Art Schaldenbrand
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.