RobertZ
Community Member
![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif) ![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif)
Offline
![](https://designers-guide.org/forum/avatars/smurfs.gif)
the art of analog
Posts: 55
San Diego, CA
|
Hi, all,
In a DC operation point simulation, the simulator tried "homotopy = gmin" first and failed; then it tried "homotopy = source" and failed again; at last, it tried "homotopy = dptran" and successed.
So, in the above situation, do I need to change some settings of the simulator, or do I need to re-design my circuit?
I have read the 2nd chapter of Ken's book, but not found the answer of my questions.
Any commends are welcome!!
Thanks advance. -driveforce
|