Designer’s Guide Community

‹ Previous topic | Next topic ›

Pages: 1

pnoise timedomain simulates extra time point (Read 2444 times)

huber

Community Member

Offline

GO BEARS!

Posts: 45
Los Angeles

pnoise timedomain simulates extra time point
Aug 31^st, 2005, 7:38pm

Hello-
I'm trying to simulate the noise performance of a CMOS track-and-hold with spectreRF. I set noisetype=timedomain, numberofpoints=1, and noisetimepoints=[5.34e-9]. When I run the simulation it simulates an extra time point at t=0 (on the pss time axis), doubling the simulation time. Is there any way to make the simulator not do the t=0 time point?
Thanks,
-Dan

IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: pnoise timedomain simulates extra time point Reply #1 - Aug 31^st, 2005, 9:39pm Dan, Set numberofpoints to 0. numberofpoints is used to distribute timepoints over the period, in addition to any specified in noisetimepoints. If you don't want any distributed timepoints, set it to 0. Regards, Andrew.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›