Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Aug 16^th, 2024, 8:15am

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Simulators › RF Simulators › DSB or SSB NF for direct conversion receiver

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

DSB or SSB NF for direct conversion receiver (Read 4263 times)

milkdragon Junior Member Offline RF idiot Posts: 30	DSB or SSB NF for direct conversion receiver Sep 01^st, 2005, 5:36pm Hi all, Should i use DSB NF for the direct conversion receiver? I am doing simulation in SpectreRF and see different option to plot NF, one call NFieee, could any one tell what is it? Thank you
Back to top	IP Logged

Eugene Senior Member Offline Posts: 262	Re: DSB or SSB NF for direct conversion receiver Reply #1 - Sep 1^st, 2005, 7:03pm I am not yet familiar with the IEEE option but for direct conversion receivers I use the DSB option because the signal has power on both sides of the carrier.
Back to top	IP Logged

Frank Wiedmann Community Fellow Offline Posts: 678 Munich, Germany	Re: DSB or SSB NF for direct conversion receiver Reply #2 - Sep 1^st, 2005, 11:21pm See http://www.cadence.com/whitepapers/pspapn1.pdf (this is also an appendix of the SpectreRF User Guide).
Back to top	IP Logged

milkdragon Junior Member Offline RF idiot Posts: 30	Re: DSB or SSB NF for direct conversion receiver Reply #3 - Sep 2^nd, 2005, 9:45am Thank you
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.