Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

May 17^th, 2024, 2:46am

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Design › Analog Design › Channel Charge Injection Simulation

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Channel Charge Injection Simulation (Read 3684 times)

Raj New Member Offline Posts: 4 India	Channel Charge Injection Simulation Oct 06^th, 2005, 11:14pm Hello All, Can anyone tell me the way to simulate Channel Charge Injection. Does Spectre and SmartSpice support this? Thanks in advance, Packiaraj.V.
Back to top	IP Logged

juddy New Member Offline Posts: 3	Re: Channel Charge Injection Simulation Reply #1 - Oct 23^rd, 2005, 11:44am I am also Confused about this. I wonder if the BSim3 model has corresponding parameters? Anyboby Helps?
Back to top	IP Logged

ywguo Community Fellow Offline Posts: 943 Shanghai, PRC	Re: Channel Charge Injection Simulation Reply #2 - Oct 26^th, 2005, 3:16am Hi, I'm not familiar with BSIM3 model, but I'm sure that you will see channel charge injection if you simulate a MOS switch using SPICE like simulator. Best regards, Yawei
Back to top	IP Logged

Paul Community Fellow Offline Posts: 351 Switzerland	Re: Channel Charge Injection Simulation Reply #3 - Oct 26^th, 2005, 12:14pm Hi, I agree with Yawei. The MOS model you use may influence the accuracy of the injected charge, as different channel charge definitions are used throughout the device models. Paul
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.