The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 20th, 2024, 10:11am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › AVANWAVES Help I canīt see Delta X.
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
AVANWAVES Help I canīt see Delta X. (Read 1953 times)
negil
New Member
*
Offline



Posts: 1
AVANWAVES Help I canīt see Delta X.
Nov 03rd, 2005, 9:19pm  
Hi,

Does anybody knows what should I do to see Delta X in the window panel in Avanwaves.

I am measuring propagation delay but I canīt see Delta X when I click the output waveform with point to point measurement even though I have marked Delta X in Measurement lanel options.

Is there any other way to measure propagation delay in avanwaves than using Delta X?
Back to top
 
 
View Profile   IP Logged
spiceoracle
Junior Member
**
Offline



Posts: 21
USA
Re: AVANWAVES Help I canīt see Delta X.
Reply #1 - Jan 5th, 2006, 2:58pm  
Are you trying to do a point to point measurement between two signals?  If so, this is not possible in AvanWaves.  The point to point measurement will only give you the delta between two points on the same signal.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.