Designer’s Guide Community

‹ Previous topic | Next topic ›

Pages: 1

save operation region with spectre? (Read 2951 times)

Narya

New Member

Offline

I love spectre,
Cadence IC 5.0!

Posts: 1

save operation region with spectre?
Nov 04^th, 2005, 5:20pm

Hi guys, with spectre I tried to save the operation region of a MOS transistor using following statement:

save M1:region

However, spectre complained that "region" is an invalid parameter and ignored the statement. The "region" parameter is indeed listed as one of the operating-point parameters for BSIM3v3 model in spectre documentation. I tried several other op-point parameters such as gm and vth, and spectre worked well.

So how can I save the operation region ONLY? Any help is appreciated, thanks a lot!

IP Logged

rf-design Senior Member Offline Reiner Franke Posts: 165 Germany	Re: save operation region with spectre? Reply #1 - Nov 6^th, 2005, 12:49pm I am not shure but if you type spectre -help bsim3v3 you will get a list of model/instance/op parameter. You have to possible use another syntax.
Back to top	IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: save operation region with spectre? Reply #2 - Nov 15^th, 2005, 11:33am I just tried this, and you're right. It doesn't work. I found PCR 697454 which suggested it was fixed in MMSIM60 - but it doesn't seem to be when I tried it. I'll check why not... Andrew.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›