The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 10:26am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › current measurement in hspice ---issue
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
current measurement in hspice ---issue (Read 2309 times)
curious
New Member
*
Offline



Posts: 7
current measurement in hspice ---issue
Apr 07th, 2006, 6:53pm  
Hello all,

I was measuring the current through a source. So when the current is flowing in to the souce it should plot positive current but it plots the current is negative.
I am attaching the circuit which I am talking about.
Please let me know what the problem is?

Thank you,
c
Back to top
forum.pdf  
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: current measurement in hspice ---issue
Reply #1 - Apr 25th, 2006, 5:46am  
You might want to check your Hspice manual on sign conventions.  Eg, I recall that current into a MOS drain is positive, but current *out* of the source is positive.
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.