Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Apr 30^th, 2024, 3:01am

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Simulators › AMS Simulators › simulation AC in AMS environment

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

simulation AC in AMS environment (Read 3041 times)

Pavel Senior Member Offline Posts: 174 Lausanne/Switzerland	simulation AC in AMS environment Oct 31^st, 2006, 8:37am Hello I have a filter described in Verilog-A. How can I simulate it in AC. Should I - create symbol of this filter - do shematic with it and some source - call Analog Design Environment or there is more simple way to proceed? Thanks in advance. Pavel.
Back to top	IP Logged

ACWWong Community Fellow Offline Posts: 539 Oxford, UK	Re: simulation AC in AMS environment Reply #1 - Nov 1^st, 2006, 7:02am what you suggest is what i would do to setup an ac simulation of your verilogA code.
Back to top	IP Logged

Geoffrey_Coram Senior Fellow Offline Posts: 1998 Massachusetts, USA	Re: simulation AC in AMS environment Reply #2 - Nov 2^nd, 2006, 4:54am I'd just write a spectre netlist by hand and run spectre from the command line ...
Back to top	If at first you do succeed, STOP, raise your standards, and stop wasting your time. IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.