The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 8:39am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Calulator mode
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Calulator mode (Read 3211 times)
danda821
Junior Member
**
Offline



Posts: 27
Calulator mode
Jan 19th, 2007, 7:27am  
I am wondering how to select the cadence calculator mode (SKILL or MDL). I know run wavescan -expr SKILL can select SKILL mode. But when I run calculator from icfb Tools menu, can I select the mode? Thanks.
Back to top
 
 
View Profile   IP Logged
Andrew Beckett
Senior Fellow
******
Offline

Life, don't talk to
me about Life...

Posts: 1742
Bracknell, UK
Re: Calulator mode
Reply #1 - Jan 22nd, 2007, 4:00am  
When you invoke the calculator from within DFII, it will always be in SKILL mode, because it is intended to be used with ADE, which expects SKILL expressions.

Regards,

Andrew.
Back to top
 
 
View Profile WWW   IP Logged
topquark
Community Member
***
Offline



Posts: 61
Thames Valley, UK
Re: Calulator mode
Reply #2 - Jan 23rd, 2007, 5:08am  
Type wavescan -expr mdl on the command line to get the MDL results browser.
From there, you can launch the calculator in MDL mode
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.