Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Jul 22^nd, 2024, 3:37pm

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Simulators › Circuit Simulators › dcmatch sweep analysis in Cadence often fails

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

dcmatch sweep analysis in Cadence often fails (Read 3325 times)

gsheng New Member Offline Posts: 4	dcmatch sweep analysis in Cadence often fails Feb 06^th, 2007, 11:41pm When I ran dcmatch sweep analysis, spectre always failed to converge. But when I ran simple dcmatch(just one value), it seems to be OK. Any comment?
Back to top	IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: dcmatch sweep analysis in Cadence often fails Reply #1 - Feb 7^th, 2007, 3:42am Does the same thing happen if you do a dc sweep (sweeping the same thing you're sweeping in the dcmatch)? Regards, Andrew.
Back to top	IP Logged

gsheng New Member Offline Posts: 4	Re: dcmatch sweep analysis in Cadence often fails Reply #2 - Feb 13^th, 2007, 5:03am dc sweep is OK.
Back to top	IP Logged

Andrew Beckett Senior Fellow Offline Life, don't talk to me about Life... Posts: 1742 Bracknell, UK	Re: dcmatch sweep analysis in Cadence often fails Reply #3 - Feb 22^nd, 2007, 11:54am I find this surprising. You should report this to Cadence customer support. Regards, Andrew.
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.