The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 21st, 2024, 5:10am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › how to change the axis variables in Cosmos Scope
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
how to change the axis variables in Cosmos Scope (Read 2022 times)
Julian18
Community Member
***
Offline



Posts: 55
how to change the axis variables in Cosmos Scope
Apr 23rd, 2007, 1:36am  
Hi, there.
    I wonder if it is possible to change the default axis variables (time, frequency,etc.) to another variable, such as voltage, current, or even user defined parameters, If possible, how could i do that?

TIA!!

Julian
Back to top
 
 
View Profile   IP Logged
Geoffrey_Coram
Senior Fellow
******
Offline



Posts: 1999
Massachusetts, USA
Re: how to change the axis variables in Cosmos Sco
Reply #1 - Apr 23rd, 2007, 4:13am  
Once upon a time I did an ac analysis with a dc sweep; the default axis was frequency, but I was able to switch to plotting the variables against the dc sweep variable (voltage in my case).
Back to top
 
 
If at first you do succeed, STOP, raise your standards, and stop wasting your time.
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.