The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 17th, 2024, 7:17pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › RF Design › how to measure front end linearity
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
how to measure front end linearity (Read 1780 times)
James Bond
Community Member
***
Offline



Posts: 82
how to measure front end linearity
Jul 30th, 2007, 2:19am  
Hi, all

Can anybody here tell me how to test RF front end linearity in SpectreRF? I know how to test lna linearity and mixer linearity. But when they come together, how to set the pss simulation ? Can anybody share the manual? Thank you very much.

Best Regards
james
Back to top
 
 
View Profile   IP Logged
m
New Member
*
Offline



Posts: 6
Re: how to measure front end linearity
Reply #1 - Aug 1st, 2007, 9:31am  
Just use the same method as you use in mixer linearity simulation. I guess you are talking about IP3 testing. You can use tran or pss for IP3.
Smiley
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.