Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Oct 31^st, 2024, 5:41pm

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Design › Analog Design › Post-Layout simulation using UMC 0.18um RF technol

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Post-Layout simulation using UMC 0.18um RF technol (Read 2394 times)

DoYouLinux Community Member Offline Posts: 80	Post-Layout simulation using UMC 0.18um RF technol Sep 27^th, 2007, 12:28pm Hi all, Just would like to know that, has anyone been able to do a Post-Layout simulation in Cadence using a UMC 0.18mm RF technology ? I have know from many friends that UMC don't provide a technology file to do a post-layout simulation, but I am not sure about this. Thank you so much, DYLinux
Back to top	IP Logged

didac Senior Member Offline There's a million ways to see the things in life Posts: 247 manresa,spain	Re: Post-Layout simulation using UMC 0.18um RF tec Reply #1 - Sep 27^th, 2007, 12:43pm Hi DYLinux , I've been working all the past year with UMC 0.18um RF design kit and I can say that it's perfectly possible to perform post-layout simulation. Check your PDK documentation and if I remember well there's a section dedicated to ASSURA tool. Hope it helps,
Back to top	IP Logged

DoYouLinux Community Member Offline Posts: 80	Re: Post-Layout simulation using UMC 0.18um RF tec Reply #2 - Sep 27^th, 2007, 12:55pm Thanks a lot, Didac ;) I will have a look with it and post a feedback about this again :) DYLinux
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.