Designer’s Guide Community

Pages: 1

how to run spectre by netlist only (Read 2256 times)

jlee Community Member Offline Posts: 40	how to run spectre by netlist only Dec 20^th, 2007, 8:56pm Dear all, How can I run spectre/specreRF simlation by netlist only instead of the traditional way, i.e. capature a schematic, use ADE to generate a netlist and then run simulation? Thanks Jason Lee
Back to top	IP Logged

rajdeep

Senior Member

Offline

Posts: 220
UK

Re: how to run spectre by netlist only
Reply #1 - Dec 20^th, 2007, 10:02pm

Hi Jason,

It is pretty easy. Just type spectre <netlist.scs> in your terminal. If the path is not set for spectre then you have to give the absolute path for spectre. One easy way to find the exact command that ADE runs when you press RUN+SIMULATION button is to go to the simulation directory (where all your simulation data get dumped) and look for the script runsimulation.

Hope, that helps.
Rajdeep

Design is fun, verification is a requirement.

IP Logged

jlee Community Member Offline Posts: 40	Re: how to run spectre by netlist only Reply #2 - Dec 20^th, 2007, 10:18pm Got it! Thanks, Rejdeep
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›