The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 3rd, 2024, 6:57am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Comparator's offset
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Comparator's offset (Read 1941 times)
taos
New Member
*
Offline



Posts: 8
Comparator's offset
Feb 25th, 2008, 11:48pm  
Can the offset of comparator be gotton by simulation?
How to get it through Hspice?
Thanks!
Back to top
 
 
View Profile   IP Logged
achim.graupner
Community Member
***
Offline



Posts: 51
Re: Comparator's offset
Reply #1 - Feb 25th, 2008, 11:57pm  
Dear taos,

you might like to read the article as starting point. This approach however can be optimized further.

http://www.designers-guide.org/Analysis/comparator.pdf

Regards,
Achim
Back to top
 
 
Achim Graupner
ZMD AG, Dresden, Silicon Saxony, Germany
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.