Forum
Forum
Verilog-AMS
Analysis
Modeling
Design
Theory
Welcome, Guest. Please
Login
or
Register.
Please follow the Forum
guidelines
.
Aug 18
th
, 2024, 3:40am
Home
Help
Search
Login
Register
PM to admin
The Designer's Guide Community Forum
›
Simulators
›
Circuit Simulators
› Comparator's offset
‹
Previous topic
|
Next topic
›
Pages: 1
Comparator's offset (Read 2004 times)
taos
New Member
Offline
Posts: 8
Comparator's offset
Feb 25
th
, 2008, 11:48pm
Can the offset of comparator be gotton by simulation?
How to get it through Hspice?
Thanks!
Back to top
IP Logged
achim.graupner
Community Member
Offline
Posts: 51
Re: Comparator's offset
Reply #1 -
Feb 25
th
, 2008, 11:57pm
Dear taos,
you might like to read the article as starting point. This approach however can be optimized further.
http://www.designers-guide.org/Analysis/comparator.pdf
Regards,
Achim
Back to top
Achim Graupner
ZMD AG, Dresden, Silicon Saxony, Germany
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent Posts
» 10 most recent Topics
Design
- RF Design
- Analog Design
- Mixed-Signal Design
- High-Speed I/O Design
- High-Power Design
- Mixed-Technology Design
Analog Verification
- Analog Functional Verification
- Analog Performance Verification
Measurements
- RF Measurements
- Phase Noise and Jitter Measurements
- Other Measurements
Modeling
- Semiconductor Devices
- Passive Devices
- Behavioral Models
- Transmission Lines and Other Distributed Devices
Design Languages
- Verilog-AMS
- VHDL-AMS
Simulators
»» Circuit Simulators
- RF Simulators
- AMS Simulators
- Timing Simulators
- System Simulators
- Logic Simulators
Other CAD Tools
- Entry Tools
- Physical Verification, Extraction and Analysis
- Unmet Needs in Analog CAD
General
- Tech Talk
- News
- Comments and Suggestions
- Opportunities
« Home
‹ Board
The Designer's Guide Community Forum
» Powered by
YaBB 2.2.2
!
YaBB
© 2000-2008. All Rights Reserved.
Copyright 2002-2024
Designer’s Guide Consulting, Inc.
Designer’s Guide
® is a registered trademark of
Designer’s Guide Consulting, Inc.
All rights reserved.
Send comments or questions to
editor@designers-guide.org
. Consider
submitting
a paper or model.