Stefan
|
Hi Scott,
I don't get your point. If you simply specify two input/output pin in your sourcecode to act as power supplie input(!), then you shouldn't get any messages like voltage loops.
Your sourcecode of the model should look like this: module NAME(vddpin,gndpin) inout vddpin,gndpin; electrical vddpin,gndpin; analog begin if V(vddpin,gndpin) > necessarysupplyvoltage begin // functionality here end // this is for virtual power consumption I(vddpin,gndpin) <+ V(vddpin,gndpin)/ R_something; end endmodule
Regards,
Stefan
|