Designer’s Guide Community :: Forum

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Jul 17^th, 2024, 7:22am

	HomeHelpSearchLoginRegisterPM to admin

The Designer's Guide Community Forum › Simulators › AMS Simulators › ncsim: *internal* (sv_seghandler - trapno -1)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

ncsim: *internal* (sv_seghandler - trapno -1) (Read 6062 times)

Upemba Junior Member Offline Posts: 10	*ncsim: internal* (sv_seghandler - trapno -1)** Jun 19^th, 2008, 1:49pm Is any body familiar with the following error while running an AMS simulation in ADE. Thanks
Back to top	IP Logged

Stefan Senior Member Offline Posts: 124	*Re: ncsim: internal* (sv_seghandler - trapno -1) Reply #1 -** Jun 19^th, 2008, 1:55pm Yes - it's an internal error that occurs sometimes. You really need to give some more informations, like sourcecode and so on to be able to tell if this is a common error. Otherwise a complete bug report to cadence is your only possibility...
Back to top	IP Logged

jbdavid Community Fellow Offline Posts: 378 Silicon Valley	*Re: ncsim: internal* (sv_seghandler - trapno -1) Reply #2 -** Jun 19^th, 2008, 7:59pm happens a lot .. bad code poorly written verilog and various other reasons.. etc.. if you have this it means you hit a corner case cadence hasn't written a real message for.. two choices.. retrace your steps and figure out where you made the mistake.. or Call cadence.
Back to top	jbdavid Mixed Signal Design Verification IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.