The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 17th, 2024, 2:39pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › CMOS Operational Amplifier
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
CMOS Operational Amplifier (Read 1604 times)
midou
New Member
*
Offline



Posts: 5
TUNISIA
CMOS Operational Amplifier
Jul 02nd, 2008, 1:06am  
hey,

I want to know the total input noise of the CMOS Operational Amplifier..

so, what simulation must be done..?

(I use the "Spectre" simulator--CADENCE tool)

Smiley Wink
Back to top
 
 
View Profile midou midou   IP Logged
aaron_do
Senior Fellow
******
Offline



Posts: 1398
Re: CMOS Operational Amplifier
Reply #1 - Jul 2nd, 2008, 8:03am  
Use the "noise" simulation. Just set the start and stop frequency, and select the output nodes and the input voltage source. If you want total nosie in V2, you need to integrate over frequency.

BTW you don't need to post your question more than once next time...

cheers,
Aaron
Back to top
 
 
there is no energy in matter other than that received from the environment - Nikola Tesla
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.