The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 4th, 2024, 10:58am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Measurements › Phase Noise and Jitter Measurements › Residual FM
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Residual FM (Read 736 times)
Zero
New Member
*
Offline



Posts: 3
Residual FM
Oct 30th, 2008, 11:34am  
What is the definition of the "Residual FM" noise ? And how it is measured ?

Thanks.
Back to top
 
 
View Profile   IP Logged
SSA@A
New Member
*
Offline



Posts: 6
Re: Residual FM
Reply #1 - May 6th, 2010, 9:50pm  
>What is the definition of the "Residual FM" noise ?

FYI.
http://cp.literature.agilent.com/litweb/pdf/genesys200801/syn/pll_concepts/noise...

>And how it is measured ?

Use the signal source analyzer.
Residual FM is calculated from the phase noise trace. the equation is available on the part of “Confirming Integral Phase Noise, Jitter and Residual FM“ in the following on-line manual.
http://ssa.tm.agilent.com/e5052b/manuals/webhelp/eng/measurement/phase_noise_mea...
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.