The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Aug 15th, 2024, 1:25pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Analog Design › dynamic range
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
dynamic range (Read 1982 times)
anil reddy
New Member
*
Offline



Posts: 9
India
dynamic range
Mar 10th, 2009, 12:24am  
hi! everyone..

what is the def. of dynamic range? is it the ratio of max o/p swing to min.o/p swing?

any comments on that...

thank u..
Back to top
 
 
View Profile   IP Logged
raja.cedt
Senior Fellow
******
Offline



Posts: 1516
Germany
Re: dynamic range
Reply #1 - Mar 10th, 2009, 3:27am  
hi,
   dynamic range is the ration of signal power by noise power,in some some sense your def also seems correct,.but use this.U can get same from google.
Thank you,
Rajasekhar.
Back to top
 
 
View Profile WWW raja.sekhar86   IP Logged
Sarig
Junior Member
**
Offline



Posts: 31
Re: dynamic range
Reply #2 - Mar 10th, 2009, 1:34pm  
Max Signal / Noise floor  [ At each Freq.]
or
Max Singal / integrated input refered noise (rms)
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.