Designer’s Guide Community

Pages: 1

Monte Carlo Similulation in ADE XL (Read 2609 times)

Fadi New Member Offline Posts: 1	Monte Carlo Similulation in ADE XL Apr 30^th, 2009, 10:16pm I was trying to figure out how to run a monte carlo simulation in ADE XL. Can some one help me with this or point to a good tutorial on the subject. Thnx
Back to top	IP Logged

Andrew Beckett

Senior Fellow

Offline

Life, don't talk to
me about Life...

Posts: 1742
Bracknell, UK

Re: Monte Carlo Similulation in ADE XL
Reply #1 - May 1^st, 2009, 5:37am

Did you try reading the manual?

With IC612/IC613 you should be able to either invoke "cdnshelp" from the command line, or use the Help menus in the tools to navigate the help system.

Worst case, take a look at <ICinstDir>/adexl/adexl.pdf

In the version I looked at (latest IC613 ISR), Chapter 7 is "Performing Monte Carlo Analysis".

Regards,

Andrew.

IP Logged

Pages: 1

‹ Previous topic | Next topic ›