The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 10:36am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › startup circuit..initial conditions..trans sim
‹ Previous topic | Next topic ›
Pages: 1 2 
Send Topic Print
startup circuit..initial conditions..trans sim (Read 4115 times)
raja.cedt
Senior Fellow
******
Offline



Posts: 1516
Germany
Re: startup circuit..initial conditions..trans sim
Reply #15 - May 27th, 2009, 9:31pm  
hi,
 seems like some mistake is there while confirm about settling time.Do the following
1.rum .tran without startup ckt but initialize some node
2.run .tran with startup and this time don't initialize any node.

thanks,
rajasekhar
Back to top
 
 
View Profile WWW raja.sekhar86   IP Logged
somisetty
Community Member
***
Offline



Posts: 64
Re: startup circuit..initial conditions..trans sim
Reply #16 - May 27th, 2009, 11:26pm  
Hi Rajasekhar,

Thanks for the reply...

you mean to say that i need to compare the settling time's of 1 and 2 ?
1.run .tran without startup ckt but initialize some node
2.run .tran with startup and this time don't initialize any node.

Thanks,
SOmisetty
Back to top
 
 
View Profile   IP Logged
raja.cedt
Senior Fellow
******
Offline



Posts: 1516
Germany
Re: startup circuit..initial conditions..trans sim
Reply #17 - May 28th, 2009, 1:18am  
yes..you do those simulations  and see is these discrepancy of operating point along with all dynamics between them.

Thanks,
Rajasekhar.
Back to top
 
 
View Profile WWW raja.sekhar86   IP Logged
Pages: 1 2 
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.