qiushidaren
Community Member
Offline
I am a lovely MOSFET!
Posts: 86
Chengdu
|
Dear all,
I met some issues when I try to simulate a PLL circuit, I don’t know what’s going on, could you help me, thank you in advance.
Here are the issues below: 1.Could not save cellView pll passive_flfr schematic dbsave: Failed to save cellView (passive_flfr schematic) Disc quota exceeded. 2.Warning from spectre during initial setup. I0.I0.M0: Parasitic resistor ‘rs’ has been deleted because its value of 404.762 uohm (R/MFactor) was smaller than ‘minr’. I0.I0.M0: Parasitic resistor ‘rs’ has been deleted because its value of 404.762 uohm (R/MFactor) was smaller than ‘minr’.
-Terry
|