qiushidaren
Community Member
![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif) ![* *](https://designers-guide.org/forum/Templates/Forum/default/stargold.gif)
Offline
![](http://bbs.putclub.com/uploads/av-324283.jpg)
I am a lovely MOSFET!
Posts: 86
Chengdu
|
Dear all,
I met some issues when I try to simulate a PLL circuit, I don’t know what’s going on, could you help me, thank you in advance.
Here are the issues below: 1.Could not save cellView pll passive_flfr schematic dbsave: Failed to save cellView (passive_flfr schematic) Disc quota exceeded. 2.Warning from spectre during initial setup. I0.I0.M0: Parasitic resistor ‘rs’ has been deleted because its value of 404.762 uohm (R/MFactor) was smaller than ‘minr’. I0.I0.M0: Parasitic resistor ‘rs’ has been deleted because its value of 404.762 uohm (R/MFactor) was smaller than ‘minr’.
-Terry
|