I am trying to do a circuit simulation to report operating point conditions (gm, gds, vth, etc) after the circuit has started up and run for a few 100ns.
I need to report the results in Ocean for further analysis. I can get at some of the information with
infotimes in transient analysis followed by numerous mouse clicks in the results browser, but this process is not easily repeatable. I need the results in Ocean so that they are repeatable.
I looked through a few other threads but I didn't see how to get gm, gds etc.:
http://www.designers-guide.org/Forum/YaBB.pl?num=1225386917Here is my analysis code that I am currently using:
Code:analysis('tran ?stop "500n" ?errpreset "conservative" ?infotimes list("300n") )
analysis('dc ?saveOppoint t ?save "all" )
envOption(
'analysisOrder list("tran" "dc")
)
The 'analsysOrder command works, but the dc anal is unrelated to the transient anal.