The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 18th, 2024, 11:48pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › RF Design › Moved: how to give a complex source impedance in port or p1_tone?
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Moved: how to give a complex source impedance in port or p1_tone? (Read 1128 times)
liletian
Community Member
***
Offline



Posts: 97
MD
Moved: how to give a complex source impedance in port or p1_tone?
May 07th, 2010, 8:46am  
This Topic has been moved to RF Simulators by Ken Kundert.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.