The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 18th, 2024, 3:33am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Unable to change x-axis to one of the result waveform in Wavescan
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Unable to change x-axis to one of the result waveform in Wavescan (Read 1485 times)
supermoment
Senior Member
****
Offline



Posts: 167
Unable to change x-axis to one of the result waveform in Wavescan
May 12th, 2010, 8:57pm  
Unable to change x-axis to one of the result waveform in Wavescan ic5141
The function is there, but it is not function.

I found wavescan difficult to use compared to AWD.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.