The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 12th, 2024, 6:19pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Monte Carlo/TSMC
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Monte Carlo/TSMC (Read 2116 times)
memomemomemo
New Member
*
Offline



Posts: 8
Monte Carlo/TSMC
Aug 18th, 2010, 2:38am  
Hi!

I am doing Monte Carlo simulation ( 90nm TSMC Process) with cadence5. I can see the process variation for mos transistors however not the mismatch.

How can I find out what is wrong? Should I enable or add a model library?

Thanks!
Mehmet
Back to top
 
 
View Profile   IP Logged
mydreamhouse
Junior Member
**
Offline



Posts: 23
Re: Monte Carlo/TSMC
Reply #1 - Aug 22nd, 2010, 5:13am  
before run monte carlo simulation,   you should do:
(1)use mismatch symbol in PDK
(2)use mc_ section in library
Back to top
 
 
View Profile mydreamhouse   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.