The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 19th, 2024, 10:18am
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › Transient Simulation under Spectre
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Transient Simulation under Spectre (Read 1695 times)
pcardoso73
Junior Member
**
Offline



Posts: 25
Portugal
Transient Simulation under Spectre
Dec 17th, 2010, 7:37am  
Hi,

I would like to do a transient simulation, but save only transient points after a certain time. For eg. my simulation runs from 0 until 500us, and I would like to save only from 400u to 500u. How can I do this ?

Best regards,
Pedro Cardoso
Back to top
 
 
View Profile   IP Logged
Ken Kundert
Global Moderator
*****
Offline



Posts: 2386
Silicon Valley
Re: Transient Simulation under Spectre
Reply #1 - Dec 17th, 2010, 10:13pm  
use the outputstart transient analysis parameter.

-Ken
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.