The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Sep 9th, 2024, 7:08pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Mixed-Signal Design › SAR ADC design (need help)
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
SAR ADC design (need help) (Read 2430 times)
seenu
New Member
*
Offline



Posts: 3
guwahati
SAR ADC design (need help)
Jun 29th, 2011, 9:11am  
Hi,
  please help that what are the specifications for DAC design for SAR low power 4-bit ADC...please help me to come out of this problem
Back to top
 
 
View Profile   IP Logged
raja.cedt
Senior Fellow
******
Offline



Posts: 1516
Germany
Re: SAR ADC design (need help)
Reply #1 - Jun 29th, 2011, 9:31pm  
hi, for any Dacs specification will be same. But for SAR  adc based on INL ,DNL spec you should find proper unit cap (based on noise also).
Please refer recent literature by Anatha Chandra Kansan from MIT.

Thanks.
Back to top
 
 
View Profile WWW raja.sekhar86   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.